Installation manual

2-7
Installing the Hub
Installation Summary
Installing the Hub
.
3. Place the hub in the rack and lower it so the notches in the bottom of the
bracket slide onto the screws. Tighten these screws-be careful not to
overtighten them.
4. Install the other number 12-24 screw into the upper hole in each bracket.
Tighten these screws-be careful not to overtighten them.
Partially install a
screw into the top
hole of a close
(0.5-inch) pair
on both sides
of the rack
Roadhw0.bk : ROADHW2.FM Page 7 Thursday, May 28, 1998 5:40 PM