Specifications
Table Of Contents
- Product Features
- Activating and Customizing the Software
- Computer Setup (F10) Utility
- Illustrated parts catalog
- Serial ATA (SATA) Drive Guidelines and Features
- Routine Care and Disassembly Preparation
- Removal and Replacement Procedures – Microtower (MT) Chassis
- Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
- Troubleshooting Without Diagnostics
- Safety and Comfort
- Before You Call for Technical Support
- Helpful Hints
- Solving General Problems
- Solving Power Problems
- Solving Hard Drive Problems
- Solving Media Card Reader Problems
- Solving Display Problems
- Solving Audio Problems
- Solving Printer Problems
- Solving Keyboard and Mouse Problems
- Solving Hardware Installation Problems
- Solving Network Problems
- Solving Memory Problems
- Solving Processor Problems
- Solving CD-ROM and DVD Problems
- Solving USB Flash Drive Problems
- Solving Front Panel Component Problems
- Solving Internet Access Problems
- Solving Software Problems
- Contacting Customer Support
- HP PC Hardware Diagnostics
- Backup and Recovery
- Power Cord Set Requirements
- POST Error Messages
- Password Security and Resetting CMOS
- Specifications
- Index
Power Switch/LED Assembly
Description Spare part number
Power switch/LED assembly 657105-001
1. Prepare the computer for disassembly (Preparation for Disassembly on page 48).
2. Remove the access panel (
Access Panel on page 49).
3. Lay the computer on its side with the front facing toward you.
4. Remove the front bezel (
Front Bezel on page 51).
5. Remove the optical drive (
Removing an Optical Drive on page 73).
6. Disconnect the braided cables from the black system board connector labeled JFP1.
7. Remove the cable from the clips in the optical drive cage.
Figure 7-39 Power switch cable routing
Power Switch/LED Assembly 85