Specifications
Table Of Contents
- Product Features
- Activating and Customizing the Software
- Computer Setup (F10) Utility
- Illustrated parts catalog
- Serial ATA (SATA) Drive Guidelines and Features
- Routine Care and Disassembly Preparation
- Removal and Replacement Procedures – Microtower (MT) Chassis
- Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
- Troubleshooting Without Diagnostics
- Safety and Comfort
- Before You Call for Technical Support
- Helpful Hints
- Solving General Problems
- Solving Power Problems
- Solving Hard Drive Problems
- Solving Media Card Reader Problems
- Solving Display Problems
- Solving Audio Problems
- Solving Printer Problems
- Solving Keyboard and Mouse Problems
- Solving Hardware Installation Problems
- Solving Network Problems
- Solving Memory Problems
- Solving Processor Problems
- Solving CD-ROM and DVD Problems
- Solving USB Flash Drive Problems
- Solving Front Panel Component Problems
- Solving Internet Access Problems
- Solving Software Problems
- Contacting Customer Support
- HP PC Hardware Diagnostics
- Backup and Recovery
- Power Cord Set Requirements
- POST Error Messages
- Password Security and Resetting CMOS
- Specifications
- Index
9. Slide the hard drive out of the cage.
Figure 7-34 Disconnecting the hard drive cables
To install a hard drive, reverse the removal procedures.
When installing a hard drive, align the screw holes on the hard disk drive with the screw holes on the
cage.
Figure 7-35 Disconnecting the hard drive cables
When installing a hard drive cage, set the hard drive cage down into the bay, aligning the tabs on the
bottom of the cage with the tabs on the chassis.
Drives 81