Specifications
Table Of Contents
- Product Features
- Activating and Customizing the Software
- Computer Setup (F10) Utility
- Illustrated parts catalog
- Serial ATA (SATA) Drive Guidelines and Features
- Routine Care and Disassembly Preparation
- Removal and Replacement Procedures – Microtower (MT) Chassis
- Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
- Troubleshooting Without Diagnostics
- Safety and Comfort
- Before You Call for Technical Support
- Helpful Hints
- Solving General Problems
- Solving Power Problems
- Solving Hard Drive Problems
- Solving Media Card Reader Problems
- Solving Display Problems
- Solving Audio Problems
- Solving Printer Problems
- Solving Keyboard and Mouse Problems
- Solving Hardware Installation Problems
- Solving Network Problems
- Solving Memory Problems
- Solving Processor Problems
- Solving CD-ROM and DVD Problems
- Solving USB Flash Drive Problems
- Solving Front Panel Component Problems
- Solving Internet Access Problems
- Solving Software Problems
- Contacting Customer Support
- HP PC Hardware Diagnostics
- Backup and Recovery
- Power Cord Set Requirements
- POST Error Messages
- Password Security and Resetting CMOS
- Specifications
- Index
8. Push the optical drive from behind, and then remove it from the front of the computer.
Figure 8-17 Removing the optical drive
Removing the Hard Drive
NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive.
The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the
hard drive:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 101).
2. Remove the access panel (
Access Panel on page 102).
3. Remove the front bezel (
Front Bezel on page 104).
4. Rotate the drive cage to its upright position.
Drives 119