Specifications
Table Of Contents
- Product Features
- Activating and Customizing the Software
- Computer Setup (F10) Utility
- Illustrated parts catalog
- Serial ATA (SATA) Drive Guidelines and Features
- Routine Care and Disassembly Preparation
- Removal and Replacement Procedures – Microtower (MT) Chassis
- Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
- Troubleshooting Without Diagnostics
- Safety and Comfort
- Before You Call for Technical Support
- Helpful Hints
- Solving General Problems
- Solving Power Problems
- Solving Hard Drive Problems
- Solving Media Card Reader Problems
- Solving Display Problems
- Solving Audio Problems
- Solving Printer Problems
- Solving Keyboard and Mouse Problems
- Solving Hardware Installation Problems
- Solving Network Problems
- Solving Memory Problems
- Solving Processor Problems
- Solving CD-ROM and DVD Problems
- Solving USB Flash Drive Problems
- Solving Front Panel Component Problems
- Solving Internet Access Problems
- Solving Software Problems
- Contacting Customer Support
- HP PC Hardware Diagnostics
- Backup and Recovery
- Power Cord Set Requirements
- POST Error Messages
- Password Security and Resetting CMOS
- Specifications
- Index
b. If you are removing a PCI Express x16 card, pull the retention arm on the back of the
expansion socket away from the card and carefully rock the card back and forth until the
connectors pull free from the socket. Pull the expansion card straight up from the socket
then away from the inside of the chassis to release it from the chassis frame. Be sure not to
scrape the card against the other components.
NOTE: PCI cards and PCI Express x1 cards do not have the retention arm. PCI Express
X16 card is shown below.
Figure 8-11 Removing a standard PCI expansion card
6. Store the removed card in anti-static packaging.
7. If you are not installing a new expansion card, install an expansion slot cover to close the open
slot.
CAUTION: After removing an expansion card, you must replace it with a new card or
expansion slot cover for proper cooling of internal components during operation.
112 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis