Specifications
Table Of Contents
- Product Features
- Activating and Customizing the Software
- Computer Setup (F10) Utility
- Illustrated parts catalog
- Serial ATA (SATA) Drive Guidelines and Features
- Routine Care and Disassembly Preparation
- Removal and Replacement Procedures – Microtower (MT) Chassis
- Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
- Troubleshooting Without Diagnostics
- Safety and Comfort
- Before You Call for Technical Support
- Helpful Hints
- Solving General Problems
- Solving Power Problems
- Solving Hard Drive Problems
- Solving Media Card Reader Problems
- Solving Display Problems
- Solving Audio Problems
- Solving Printer Problems
- Solving Keyboard and Mouse Problems
- Solving Hardware Installation Problems
- Solving Network Problems
- Solving Memory Problems
- Solving Processor Problems
- Solving CD-ROM and DVD Problems
- Solving USB Flash Drive Problems
- Solving Front Panel Component Problems
- Solving Internet Access Problems
- Solving Software Problems
- Contacting Customer Support
- HP PC Hardware Diagnostics
- Backup and Recovery
- Power Cord Set Requirements
- POST Error Messages
- Password Security and Resetting CMOS
- Specifications
- Index
5. Remove the four screws that secure the power supply to the rear chassis.
Figure 7-48 Power supply screws
6. Inside of the unit, press the power supply release latch on the chassis base (1).
7. Slide the power supply toward the front of the computer (2), then lift the power supply out of the
computer (3).
Figure 7-49 Removing the power supply
To install the power supply, reverse the removal procedure.
Power Supply 97