Specifications

5. If you are removing an Intel processor, rotate the locking lever to its full open position (1), raise
and rotate the microprocessor retainer to its full open position (2), and then carefully lift the
processor from the socket (3).
CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
CAUTION: The heat sink must be installed within 24 hours of installing the processor to
prevent damage to the processor’s solder connections.
Figure 7-46 Removing an Intel processor
To install a new processor:
1. Place the processor in its socket.
2. If installing an Intel processor, close the retainer.
3. Secure the locking lever.
If reusing the existing heat sink, go to step 4.
If using a new heat sink, go to step 7.
4. If reusing the existing heat sink, clean the bottom of the heat sink with the alcohol pad provided
in the spares kit.
5. Apply the thermal grease provided in the spares kit to the top of the processor and install the
heat sink atop the processor.
6. Go to step 8.
94 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis