Specifications

Display assembly
This section describes removing the display assembly in its entirety and disassembling all the display
subcomponents.
If you only need to remove the display bezel, webcam/microphone module, or display panel, you do
not need to remove the entire display assembly from the computer. See
Display subcomponents
(bezel, webcam, panel) on page 33 for more information about removing the display subcomponents
that do not require that you remove the entire display assembly from the computer.
Description Spare part number
39.6-cm (15.6-inch), HD, LED, BrightView display panel 689690-001
Antennas (includes wireless antenna cables and transceivers) 689670-001
Display bezel for use with Compaq models 689676-001
Display bezel for use with HP models 689675-001
Display cable (includes display panel cable and webcam/microphone cable) 689677-001
Display enclosure for use with Compaq models 689673-001
Display enclosure for use with black HP models 689672-001
Display enclosure for use with blue HP models 689671-001
Hinges (includes hinges and left and right hinge covers) 689679-001
Webcam/microphone module 685112-001
Before removing the display assembly in its entirety, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 32).
5. Disconnect the WLAN module antenna cables from the WLAN module (see
WLAN module
on page 41).
6. Remove the following components:
●
Hard drive (see
Hard drive on page 46)
●
Keyboard (see
Keyboard on page 51)
●
Top cover (see
Top cover on page 55)
●
USB board (see
USB board on page 65)
●
Power connector cable (see
Power connector cable on page 67)
Component replacement procedures 69