Specifications

Power connector cable
Description Spare part number
Power connector cable 689678-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 32), and then remove the following components:
●
Memory module/wireless module compartment cover (see
WLAN module on page 41)
●
Hard drive (see
Hard drive on page 46)
●
Keyboard (see
Keyboard on page 51)
●
Top cover (see
Top cover on page 55)
To remove the power connector cable:
1. Position the computer upright with the right side toward you.
2. Disconnect the power connector cable (1) from the system board.
3. Release the power connector cable from the clips (2) built into the base enclosure.
Component replacement procedures 67