Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 7
53-1002149-01
Viewing and configuring system message logs
1
Type <CR> to continue, Q<CR> to stop:
2004/07/28-17:04:59, [FSSM-1003], 2,, WARNING, switch, HA State out of sync
Type <CR> to continue, Q<CR> to stop:
2004/07/28-17:04:51, [EM-1055], 3,, WARNING, switch, Media 27: Port media
incompatible
e. Reason: Configured port speed.
Type <CR> to continue, Q<CR> to stop:
Clearing the system message log
To clear the system message log for a particular switch instance, perform the following steps.
1. Log in to the switch as admin.
2. Use the errClear command to clear all messages from memory.
NOTE
For products that have a single processor, all error log messages are cleared. For products that have
multiple processors, this command only clears the error logs of the processor it is executed from.
Configuring event auditing
To configure event auditing, perform the following steps.
1. Configure the event classes you wish to audit.
switch:admin> auditcfg --class 1,2,3,4,5,6,7
Audit filter is configured.
2. Verify the configuration.
switch:admin> auditcfg --show
Audit filter is enabled.
1-ZONE
2-SECURITY
3-CONFIGURATION
4-FIRMWARE
5-FABRIC
6-FW
7-LS
3. Enable the audit feature.
switch:admin> auditcfg --enable
Audit filter is enabled.
4. Configure up to six syslog servers to receive the audit events that will be generated through
syslog (procedure will vary depending on server type).
5. Configure syslog on the switch to point to the configured servers’ IP addresses.
switch:admin> syslogdipadd 10.128.128.160
6. Verify the switch’s syslog configuration.
switch:admin> syslogdipshow