Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 5

53-1002149-01

Viewing and configuring system message logs

errDump Displays the entire error log, without page breaks. Use the -r option to show the

messages in reverse order, from newest to oldest.

errFilterSet Sets an error severity filter for the system console.

errShow Displays the entire error log, with page breaks. Use the -r option to show the messages

in reverse order, from newest to oldest.

pdShow Displays the contents of the panic dump and core dump files.

portErrShow Displays the port error summary.

portLogClear Clears the port log. If the port log is disabled, this command enables it.

portLogDisable Disables the port log facility.

portLogDump Displays the port log, without page breaks.

portLogDumpPort Displays the port log of the specified port, without page breaks.

portLogEventShow Displays which port log events are currently being reported.

portLoginShow Displays port logins.

portLogPdisc Sets or clears the debug pdisc_flag.

portLogReset Enables the port log facility.

portLogResize Resizes the port log to the specified number of entries.

portLogShow Displays the port log, with page breaks.

portLogShowPort Displays the port log of the specified port, with page breaks.

portLogTypeDisable Disables an event from reporting to the port log. Port log events are described by the

portLogEventShow command.

portLogTypeEnable Enables an event to report to the port log. Port log events are described by the

portLogEventShow command.

setVerbose Sets the verbose level of a particular module within the Fabric OS.

supportFtp Sets, clears, or displays support FTP parameters or a time interval to check the FTP

server.

supportFfdc Enables and disables first failure data capture (FFDC).

supportSave Collects RASLog, trace files, and supportShow (active CP only) information for the local

CP and then transfers the files to an FTP server. The operation can take several

minutes.

supportShow Executes a list of diagnostic and error display commands. This output is used by your

switch service provider to diagnose and correct problems with the switch. The output

from this command is very long.

syslogDIpAdd Adds an IP address as a recipient of system messages.

syslogDIpRemove Removes an IP address as a recipient of system messages.

syslogDIpShow Views the currently configured IP addresses that are recipients of system messages.

syslogdFacility Changes the syslogd facility.

systemVerification Use this command to run a comprehensive system-wide test of all switches in a

system. It will initiate a burnin run on all switches within the current system. Note that

any reference seen to slot 0 is a reference to the blade within the switch platform, for

example, Brocade 7500 and AP7600 contain FR4-18i and FA4-18 blades respectively.

TABLE 2 Commands for viewing or configuring the system parameters and logs (Continued)

Command Description