Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 49
53-1002149-01
AUTH-1016
5
AUTH-1016
Message <timestamp>, [AUTH-1016], <sequence-number>,, ERROR, <system-name>, Invalid value
to start HBA authentication port: <port number>, <pid>.
Probable Cause This may relate to an internal failure.
Recommended
Action
Copy the message, collect switch information using the supportShow command, and contact your
switch service provider.
Severity ERROR
AUTH-1017
Message <timestamp>, [AUTH-1017], <sequence-number>,, ERROR, <system-name>, Invalid value
to start authentication request: port <port number>, operation code <operation
code>.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1018
Message <timestamp>, [AUTH-1018], <sequence-number>,, ERROR, <system-name>, Invalid value
to check protocol type: port <port number>.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1020
Message <timestamp>, [AUTH-1020], <sequence-number>,, INFO, <system-name>, Failed to
create timer for authentication: port <port number>.
Probable Cause Indicates that an authentication message's timer was not created.