Basic manual

1Network setup
This section describes how to connect the HP All-in-One to a network and how to view
and manage network settings.
If you want to: See this section:
Connect to a wired (Ethernet) network. “Set up the HP All-in-One on a wired (Ethernet)
network” on page 2
Connect to a wireless network with a wireless
router (infrastructure).
“Set up the HP All-in-One on an integrated
wireless (WLAN 802.11) network”
on page 4
Connect directly to a wireless-capable
computer without a wireless router (ad hoc).
“Set up the HP All-in-One using an ad hoc
wireless connection” on page 7
Install the HP Photosmart Software for use in a
networked environment.
“Install the software for a network connection”
on page 11
Add connections to more computers on the
network.
“Connect to additional computers on a
network” on page 12
Change the HP All-in-One from a USB
connection to a network connection.
NOTE: Use the instructions in this section if
you first installed the HP All-in-One with a USB
connection, and you now want to change to
either a wireless or Ethernet network
connection.
“Change the HP All-in-One from a USB
connection to a network connection”
on page 12
View or change the network settings. “Manage your network settings” on page 14
Find troubleshooting information. “Network troubleshooting” on page 30
NOTE: You can connect the HP All-in-One to either a wireless or wired network, but
not both at the same time.
Set up the HP All-in-One on a wired (Ethernet) network
This section describes how to connect the HP All-in-One to a router, switch, or hub using
an Ethernet cable and how to install the HP Photosmart Software for a network
connection. This is known as a wired or Ethernet network.
2 Network setup
Network setup