Basic manual

5. Press the button next to the down arrow to highlight Distinctive Ring, and then press
the button next to OK.
6. Press the button next to the down arrow to highlight the appropriate option, and then
press the button next to OK.
When the phone rings with the ring pattern assigned to your fax line, the product
answers the call and receives the fax.
Set the fax header
The fax header prints your name and fax number on the top of every fax you send. HP
recommends that you set up the fax header by using the software that you installed with
the HP All-in-One. You can also set up the fax header from the control panel, as described
here.
NOTE: In some countries/regions the fax header information is a legal requirement.
To set a fax header from the control panel
1. Press the button next to Scan/Fax.
2. Press the button next to Fax Menu.
3. Press the button next to Fax Setup.
4. Press the button next to the down arrow to highlight Fax Header, and then press the
button next to OK.
5. Use the keypad to enter your personal or company name. When you have finished,
press the button next to OK.
6. Use the keypad to enter your fax number, and then press the button next to OK.
Test your fax setup
You can test your fax setup to check the status of the HP All-in-One and to make sure it
is set up properly for faxing. Perform this test after you have completed setting up the
HP All-in-One for faxing. The test does the following:
• Tests the fax hardware
• Verifies the correct type of phone cord is connected to the HP All-in-One
• Checks that the phone cord is plugged into the correct port
• Checks for a dial tone
• Checks for an active phone line
• Tests the status of your phone line connection
The HP All-in-One prints a report with the results of the test. If the test fails, review the
report for information on how to fix the problem and rerun the test.
To test your fax setup from the control panel
1. Set up the product for faxing according to your particular home or office setup
instructions.
2. Insert the print cartridges and load full-size paper in the input tray before starting the
test.
3. Press the button next to Scan/Fax.
4. Press the button next to Fax Menu.
Test your fax setup 25
Fax setup