User Manual

Environmental control system 50
The Advanced System Configuration screen displays the static IP address for each power meter, fan controls,
and other details about the HP POD 40c G2.
Perform the following tasks on this screen:
• Configure the IP address for each power meter
• Control the fans in each zone
• Control the valve
• Configure the HP POD 40c G2 serial number
• Configure the switchboard serial number
• Calibrate the flowmeter
• Calibrate the chilled water and differential pressure sensors
• Enable or disable power measurement
You must select Save to store the parameter changes in the system configuration file. If you do not save your
changes, the old parameters stored in the configuration file reload when the system starts.
CAUTION: Making changes to the ECS in the service-level area can cause the cooling system
components to fail. Only allow authorized, qualified, and trained personnel to change
configuration settings in the service-level area of the ECS.