Specifications

BUILD OR BUY: BUDGET

PC MAGAZINE SEPTEMBER 16, 2003 www.pcmag.com

Locate the AGP slot on the motherboard; it is the expan-

sion slot closest to the CPU, set back farther from the

rear of the case than the PCI connectors. Align the graph-

ics card with the slot and press it down firmly.

Double-check to make sure the AGP retention clip is seated. If it’s not, the

rear edge of the graphics card may not make proper contact with the

fingers in the socket.

Remove the floppy disk drive bay from the case by pulling back on the latch and

sliding the bay out. Install the floppy disk drive into the removable bay and fasten it into

place with small screws.

Slide the

drive bay into

the case and

snap it into

place.

Attach the small power connector and the twisted

end of the floppy disk drive’s data cable to the drive.

The other end goes into the floppy disk drive connec-

tor on the motherboard.

Install the Floppy Disk Drive

Install the Graphics Card