Warranty and Support Guide

12
FCC Regulatory and Safety Information
(USA Only)
Federal Communications Commission (FCC) Radio
Frequency Interference Statement
WARNING: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and the receiver.
•
Connect the equipment into an outlet that is
on a circuit different from the receiver.
•
Consult the dealer or an experienced
radio/TV technician for help.
The system RFI and Radiated Immunity tests
were conducted with supported peripheral
devices and shielded cables, such as those you
receive with your system. Changes or
modifications not expressly approved by the
manufacturer could void the user’s authority to
operate the equipment. To comply with the
limits for an FCC Class B computing device,
always use shielded signal cables and the
power cord supplied with this unit.
Consumer Information and FCC
Requirements
Telephone Connection
•
This equipment complies with Part 68 of the Federal
Communications Commission rules. These rules permit
this device to be directly connected to the telephone
network. Standardized jacks are used for these
connections. This equipment should not be used on
party lines or coin lines.
•
If this device is malfunctioning, it may also cause harm
to the telephone network; this device should be
disconnected until the source of the problem can be
determined and until it has been repaired. If this is not
done, the telephone company may temporarily
disconnect your service.
•
The telephone company may make changes in its
technical operations and procedures. If such changes
affect the compatibility or use of this device, the
telephone company is required to give adequate notice
of the changes.
•
If the telephone company requests information on what
equipment is connected to their lines, inform them of:
a The telephone number this unit is connected to
b The ringer equivalence number
c The USOC jack required: RJ-11C
d The FCC Registration Number
Items (b) and (c) are indicated on the label. The ringer
equivalence number (REN) is used to determine how
many devices can be connected to your telephone line.
In most areas, the sum of the RENs on any one line
should not exceed five (5.0). If too many devices are
attached, they may not ring properly.
•
In the event of equipment malfunction, the
manufacturer or an authorized repair center should
perform all repairs. It is the responsibility of users
requiring service to report the problem to the
manufacturer, or an authorized agent. Refer to “Where
to Get Help” in this document for contact information.
Statement of Fax Branding
The Consumer Protection Act of 1991 makes it unlawful
for any person to use a computer or other electronic
device to send any message via telephone fax machine,
unless it clearly contains: a margin at the top or bottom of
each transmitted page or on the first page of the
transmission, the date and time it is sent, identification of
the business or other entity, or individual sending the
message, the telephone number of the sending machine
or such business, entity, or individual.
ENERGY STAR
®
Compliance
Products marked with the ENERGY
STAR
®
logo on the packaging box
qualify with the U.S. Environmental
Protection Agency’s ENERGY STAR
®
guidelines for energy efficiency.
Products with the ENERGY STAR
®
label are designed to
use less energy, help you save money on utility bills, and
help protect the environment.
ENERGY STAR
®
is a registered trademark owned by the
U.S. government.