Quick Start Manual

Quick Start Guide

Filename: sb3rwqsK.doc Title: HP-Print2k.dot

Template: HP-Print2K.dot Author: anns Last Saved By: billm

Revision #: 142 Page: 39 of 138 Printed: 02/05/03 11:09 AM

Basics

Another way to manually put the PC into standby

is to:

1 Click Start on the taskbar.

2 Click Turn Off Computer.

3 Click Stand By.

If the PC does not work properly when you

wake it from standby, reset the PC: Press and

hold the On button on the front of the PC for

approximately 5 seconds until the system turns

off. Then turn the PC back on.

Note:

Using the On button to reset the system is not

recommended and should be used only as a

last resort.

Hibernation mode

When the PC is in hibernation mode, it saves

everything that is in PC memory to the hard

disk, turns off the monitor and the hard disk,

and then turns itself off. When you turn on the

PC, everything (programs, folders, and

documents) is restored to the screen.

To manually put the PC into hibernation:

1 Click Start on the taskbar.

2 Click Turn Off Computer.

3 Press and hold down the Shift key on the

keyboard, and click Hibernate.