Quick Start Manual

Quick Start Guide
29
Filename: sb3rwqsK.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: anns Last Saved By: billm
Revision #: 142 Page: 29 of 138 Printed: 02/05/03 11:09 AM
Basics
To connect your multi-channel
speaker system to the PC
1 Turn off the PC.
2 Connect the three audio cable plugs from the
speaker system to the connectors on the back
of the PC (see following table).
Connect speaker
channels (plugs)
To PC back
connector
Front speakers Audio (Line) Out
(lime-green)
Rear speakers Audio (Line) In (blue)
Centre/subwoofer
speakers
Mic-1 (pink)
3 Turn on the PC.
4 Turn on your speaker system.
5 Configure the multi-channel audio output;
refer to the next procedure.
To configure multi-channel audio
output for speakers configuration
1 Click Start on the taskbar.
2 Choose All Programs.
3 Click Multi-channel Sound Manager and
then click Multi-channel Sound Manager
again. The Multi-channel Audio Configuration
window opens.
Note:
If you do not see the Speaker Configuration tab,
your PC does not have the multi-channel
capability.
4 Click the Speaker Configuration tab. (Your
speakers must be connected to see this tab.)
5 Select the option describing the number
of speakers in your system, for example,
6 speaker mode (for 5.1 channels). You
can click the Speaker Test tab and then click
a speaker icon to test it.
6 Click OK.