Support Manual

Regulatory and Safety Information
Warning:
The HP Pavilion is heavy; be sure to use
ergonomically correct lifting procedures when moving the
computer.
Warning:
Electrostatic discharge (ESD) can damage disk
drives, add-in cards, and other components. If an ESD station
is not available, wear a wrist strap attached to a metal part
of the computer. Place cards on a conductive foam pad or
inside the conductive wrapper they came in; do not place the
cards on top of the wrapper.
Warning:
Do not operate the system with the cover removed.
Always replace the cover before turning on the system.
Warning:
Please read the
“
Additional Safety Information
”
located at the end of this document before installing and
connecting your system to the electrical power system.
Warning:
Using the wrong type of memory module could
damage the system.
Warning:
Do not pull the memory module out of the socket.
Use the retaining clips to eject the module.
Warning:
Do not overload the system by installing add-in
cards that draw excessive current. The system is designed
to provide 2 amps (average) of +5 V power for each
board/card in the computer. The total +5 V current draw in a
full
y
loaded s
y
stem
(
one with all add-in card slots filled
)
must
not exceed the total number of slots multiplied by 2 amps.
Warning:
Be careful of the sharp edges on the expansion slot
cover.
Warning:
There is danger of explosion if the battery is
incorrectly replaced. Replace only with the same, or
equivalent, type of battery. Discard used batteries according
to the manufacturer’s instructions.