Installation and Upgrade Guide

HP I64VMS OPENVMS V8.3-1H1 DISK$I64SYS:[VMS$COMMON.]
HP I64VMS SSL V1.3-284 DISK$I64SYS:[VMS$COMMON.]
HP I64VMS TCPIP V5.6 DISK$I64SYS:[VMS$COMMON.]
HP I64VMS TDC_RT V2.3-1 DISK$I64SYS:[VMS$COMMON.]
HP I64VMS VMS V8.3-1H1 DISK$I64SYS:[VMS$COMMON.]
HP I64VMS WBEMCIM V2.61-A070728 DISK$I64SYS:[VMS$COMMON.]
HP I64VMS WBEMPROVIDERS V1.5-31 DISK$I64SYS:[VMS$COMMON.]
Portion done: 0%..10%..20%..30%..40%..50%..60%..70%..80%..90%
%PCSI-I-PRCOUTPUT, output from subprocess follows ...
% - Execute SYS$MANAGER:TCPIP$CONFIG.COM to proceed with configuration of
% HP TCP/IP Services for OpenVMS.
%
Portion done: 100%
Depending on the options you selected, certain messages such as the preceding TCP/IP
message might be displayed at this point.
20. Final Installation Confirmation and Information Messages:The installation continues,
displaying the products that have been installed and relevant information. The version
numbers in this example do not necessarily reflect the version numbers of the products
actually shipped with OpenVMS Version 8.3-1H1.
The following products have been installed:
HP I64VMS AVAIL_MAN_BASE V8.3-1H1 Layered Product
HP I64VMS CDSA V2.3-306 Layered Product
HP I64VMS DECNET_PLUS V8.3-1H1 Layered Product
HP I64VMS DWMOTIF V1.6 Layered Product
HP I64VMS DWMOTIF_SUPPORT V8.3-1H1 Layered Product
HP I64VMS KERBEROS V3.1-152 Layered Product
HP I64VMS OPENVMS V8.3-1H1 Platform (product suite)
HP I64VMS SSL V1.3-284 Layered Product
HP I64VMS TCPIP V5.6 Layered Product
HP I64VMS TDC_RT V2.3-1 Layered Product
HP I64VMS VMS V8.3-1H1 Operating System
HP I64VMS WBEMCIM V2.61-A070728 Layered Product
HP I64VMS WBEMPROVIDERS V1.5-31 Layered Product
HP I64VMS OPENVMS V8.3-1H1: OPENVMS and related products Platform
HP I64VMS KERBEROS V3.1-152
Configure and set up Kerberos
If Kerberos will be run on this system, but has not been
used previously, you need to perform the following steps.
o Run the Kerberos configuration procedure:
@SYS$STARTUP:KRB$CONFIGURE.COM
o Add the following line to SYS$MANAGER:SYSTARTUP_VMS.COM:
$ @SYS$STARTUP:KRB$STARTUP
o Add the following line to SYS$MANAGER:SYLOGIN.COM:
$ @SYS$MANAGER:KRB$SYMBOLS
Press RETURN to continue:
HP I64VMS SSL V1.3-284: SSL for OpenVMS I64 V1.3 (Based on OpenSSL 0.9.7e)
There are post-installation tasks that you must complete
after upgrading from previous SSL versions
including verifying startup command procedures and logical names.
3.3 Installing the OpenVMS Operating System onto a System Disk 69