Installation and Upgrade Guide

The following example shows the command for unzipping an .ISO image of the latest
firmware for an rx2600 system (the file name changes with each update of the firmware
available on the website):
$ UNZIP PF_CPEAKSYS0nnn.ZIP
Archive: SYS$SYSROOT:[SYSMGR]PF_CPEAKSYS0nnn.ZIP
inflating: PF_CPEAKSYS0nnn.ISO
4. Record the data on the CD, specifying the .ISO file as the source for the CD. For instructions
on doing this, enter the following command:
$ @SYS$MANAGER:CDRECORD HELP
NOTE: OpenVMS software includes the CD recording tool CDRECORD. For online help,
enter the @SYS$MANAGER:CDRECORD HELP command at the OpenVMS DCL prompt
as shown previously. For CDRECORD source files, check the OpenVMS Open Source Tools
CD supplied with your OpenVMS I64 OE DVD. For more information about the software,
visit the following website:
http://h71000.www7.hp.com/opensource/opensource.html
1.3.4.3 Updating Your Firmware from the Firmware Update CD
You update the firmware of an entry-class Integrity server from the firmware update CD created
in the preceding section. For instructions, see the release notes provided for the firmware you
downloaded.
IMPORTANT: To update Integrity server firmware on cell-based servers, contact HP Customer
Support.
1.3.5 Device-Naming Conventions
When you perform specific operations, you are asked to specify a device name for the source
drive and one for the target drive. When specifying those device names, note the following
naming conventions:
• When the source drive is a local CD or DVD drive, the device name is similar to the following:
DQA0 (IDE drive) or DNA0 (USB drive)
For a device name, such as DQA0:, note the following conventions:
— DQ is the device code.
— A is the device controller designation.
— 0 is the unit number of the device.
• When the target drive is a local disk, the device name is similar to the following:
DKA0:
• When the source drive is a virtual DVD drive served by the InfoServer, the device name is
typically the following:
DAD1:
• On OpenVMS systems configured in certain OpenVMS Cluster or HSx environments, the
device naming convention is similar to the following:
DUA20.14.0.2.0
The values you specify identify components such as the boot device, controller, unit number
of the boot device, HSx controller node number, and channel numbers. Because these values
vary depending on your specific hardware configuration, see the owner, operator, and
technical service manuals that came with your computer for detailed information.
1.3 Examining Software and Hardware Components 31