Installation and Upgrade Guide
13. Now you can boot the OpenVMS I64 image, either using the EFI boot menu or the following
command at the EFI Shell prompt:
Shell> fs0:\efi\boot\bootia64.efi
As shown in the following example, the OpenVMS displays several messages followed by
the operating system menu. You can now begin the installation or upgrade of OpenVMS
on the Integrity server.
NOTE: The %SYSTEM-I-MOUNTVER messages and the Universal Serial Bus Configuration
Manager message are new to OpenVMS Version 8.3-1H1 and are seen only when using USB
or vMedia devices for booting the Integrity rx2660, rx3600, and rx6600 servers.
.
.
.
HP OpenVMS Industry Standard 64 Operating System, Version XBO8-O3N
© Copyright 1976-2007 Hewlett-Packard Development Company, L.P.
.
.
.
Installing required known files...
%RUN-S-PROC_ID, identification of created process is 00000024
%SYSTEM-I-MOUNTVER, DNA0: is offline. Mount verification in progress.
%SYSTEM-I-MOUNTVER, DNA0: has completed mount verification.
Universal Serial Bus Configuration Manager, Version V2.1 Reset Unconfigured devices
Configuring devices...
%PKA0, Copyright (c) 2001 LSI Logic, PKM V1.1.01 Chip LSISAS1068
%PKA0, LSISAS1068 firmware version is 1.16.0.0
%EWA0, Auto-negotiation mode assumed set by console
%EWA0, Merl5704 located in 64-bit, 66-mhz PCI-X slot
%EWA0, Device type is BCM5704C (UTP) Rev B0 (21000000)
%EWB0, Auto-negotiation mode assumed set by console
%EWB0, Merl5704 located in 64-bit, 66-mhz PCI-X slot
%EWB0, Device type is BCM5704C (UTP) Rev B0 (21000000)
%EWA0, Link up: 100 mbit, full duplex, flow control (txrx)
%EWB0, Link up: 100 mbit, full duplex, flow control (txrx)
****************************************************************
You can install or upgrade the OpenVMS I64 operating system
or you can install or upgrade layered products that are included
on the OpenVMS I64 distribution media (CD/DVD).
You can also execute DCL commands and procedures to perform
"standalone" tasks, such as backing up the system disk.
Please choose one of the following:
1) Upgrade, install or reconfigure OpenVMS I64 Version X8.3-BO8
2) Display layered products that this procedure can install
3) Install or upgrade layered products
4) Show installed products
5) Reconfigure installed products
6) Remove installed products
7) Find, Install or Undo patches; Show or Delete Recovery Data
8) Execute DCL commands and procedures
9) Shut down this system
Enter CHOICE or ? for help: (1/2/3/4/5/6/7/8/9/?)
240 Using HP SIM and vMedia to Install and Upgrade OpenVMS