Installation and Upgrade Guide

2. Make sure your Integrity server iLO 2 MP and vMedia are set up as documented in your
Integrity server hardware documentation (for example, see the HP Integrity iLO 2 MP
Operations Guide). Enable the right to use the vMedia applet.
Make sure your Integrity server is powered on. Once you connect to your server's iLO 2 MP
and log in, you can check the status and power on your Integrity server from your browser.
Select the Virtual Devices tab and access the Power & Reset screen by selecting Power
Management (on the left of the screen).
3. From a browser on a Windows-based PC or server in the same network as your Integrity
server, access your Integrity server's iLO 2 MP by specifying the DNS name or IP address.
Then log in as shown in the following example (in this example, the IP address is entered):
208 Using HP SIM and vMedia to Install and Upgrade OpenVMS