Installation and Upgrade Guide

Table 7-1 Postinstallation and Postupgrade Checklist
SectionTask
Section 7.2 (page 115)For a newly installed system disk, you can back up the disk. (At this
point, you could reinstall OpenVMS onto the disk instead.)
For a newly upgraded system disk, if it is not going to be a shadow set
member, back up the system disk as a safeguard before proceeding
with the next steps. If your newly upgraded system disk is going to
be a shadow set member, you can re-form it in a later step. As an
optional precaution, you can back up the system disk as well.
□
Section 7.3 (page 116)Register any licenses that were not registered during the installation;
for an upgrade, register any new licenses.
□
Section 7.4 (page 117)New installations only (optional): Set system parameters to enable volume
shadowing.
□
Section 7.5 (page 118)If you set system parameters to enable volume shadowing or removed
hardcoded BAP system parameters, run AUTOGEN and reboot.
□
Section 7.6 (page 118)If you want to form a shadow set for a newly installed system disk,
you can do this now or later. If you upgraded a disk in a volume
shadowing environment, re-form the shadow set.
□
New installations, some upgrades: Perform the following tasks that
generally apply to new installations only but could also apply after an
upgrade:
□
Section 7.7.1 (page 120)Create proxy files, if required.□
Section 7.7.2 (page 120)Set up the queue manager and start the default batch and print
queues.
□
Section 7.7.3 (page 121)Configure a multihead system, if applicable.□
Section 7.7.4 (page 121)Configure DECnet if it was installed. After an upgrade, perform
only if DECnet was added during the upgrade.
□
Section 7.7.5 (page 122)Configure TCP/IP Services for OpenVMS if it was installed. After
an upgrade, configure TCP/IP Services only if it was added during
the upgrade.
□
Section 7.7.6 (page 122)If you are using neither DECnet nor TCP/IP Services, install and
configure third-party networking software, if necessary.
Networking software is required to download patches and for
certain layered products.
□
Initialize or configure the following products, as needed:□
Section 7.8.1 (page 123)Initialize CDSA.□
Section 7.8.2 (page 124)Configure Availability Manager.□
Section 7.8.3 (page 125)Configure Kerberos.□
Section 7.8.4 (page 126)Configure SSL for OpenVMS.□
Section 7.8.5 (page 127)On Integrity servers using services that depend on WBEM Services
for OpenVMS, configure WBEM Services for OpenVMS.
□
Section 7.8.6 (page 131)On Integrity servers using services that depend on WBEM
Providers, configure WBEM Providers for OpenVMS.
□
Section 7.8.7 (page 132)On Integrity servers that use Instant Capacity (iCAP) or Temporary
Instant Capacity (TiCAP), configure the iCAP software.
□
Section 7.8.8 (page 132)On Integrity servers that use Pay per use (PPU), configure the
PPU software.
□
114 After Installing or Upgrading the OpenVMS Operating System