HP OpenVMS for Integrity Servers and HP OpenVMS Alpha Version 8.2

HP OpenVMS for Integrity Servers and HP OpenVMS Alpha Version 8.2 Operating Systems SPD 82.35.01
• Alpha 5/366 PICMG SBC
• Alpha 5/500 PICMG SBC
• CompactPCI CS-1000
APPENDIX A (OpenVMS Alpha)
This appendix the options supported on OpenVMS Al-
pha. Some restrictions for specific devices are listed, if
applicable.
HP reserves the right to change the number and type
of devices supported by OpenVMS Alpha, DECnet for
OpenVMS Alpha, DECnet-Plus for OpenVMS, TCP/IP
Services for OpenVMS, and OpenVMS Cluster soft-
ware. The minimum hardware requirements for future
versions and updates of these software products may
be different from current hardware requirements. For
configuration details about Alpha or VAX hardware, re-
fer to the Systems and Options Catalog and the Network
and Communications Buyers Guide.
Refer to the following SPDs for detailed product informa-
tion: DECnet for OpenVMS (SPD 48.48.xx), DECnet-
Plus for OpenVMS (SPD 50.45.xx, 25.03.xx), TCP/IP
Services for OpenVMS (SPD 46.46.xx), OpenVMS
Cluster (SPD 29.78.xx), and Open3D for OpenVMS Al-
pha (SPD 45.08.xx).
Terminals and Terminal Line Interfaces
To prevent input from overflowing a buffer, terminals use
the ASCII control characters DC1, also known as XON,
and DC3, also known as XOFF, for synchronization as
defined by HP STD 111, Revision A. VXT windowing ter-
minals support standard ANSI applications and X Win-
dows Systems using the LAT transport protocol.
The following terminals are supported by OpenVMS
Alpha:
VT200 series VT300 series VT400 series
VT500 series VXT2000 series
Disks
The following table lists the disk drives that are sup-
ported on OpenVMS Alpha, the bus the device is sup-
ported on, and the minimum required version of Open-
VMS Alpha that supports the device.
Disk Drive Description Bus
Min. Alpha
Version
ESE-52
3
120 MB solid state SDI 1.0
ESE-56 600 MB solid state SDI 1.5
ESE-58 960 MB solid state SDI 1.5
EZ31 134 MB solid state SCSI 6.2-1H3
27