Manual

2 Support matrix
Supported System Center products
The kit can be installed on the following version of SCCM:
SCCM 2012 SP1
Restrictions:
• Should be running on Windows Server 2012 or later in order for the drivers to be injected
into a WinPE 4.0 or later boot image. If running on Windows Server 2008 R2 or earlier,
refer to the Troubleshooting section.
• Must be a primary site server with the console installed.
Supported target operating systems
The following operating system can be deployed to the target servers:
Windows Server 2008 R2 x64 (SP agnostic, non-Core editions only)
Windows Server 2012 x64 (SP and edition agnostic)
Supported target servers
The following servers can be deployed to and maintained:
ML350e Gen8DL380e Gen8BL685c G7BL2x220c G7
ML350p Gen8DL380p Gen8DL120 G7BL420c Gen8
SL4540 Gen8DL385 G7DL160 Gen8BL460c G6
SL4545 G7DL385p Gen8DL320e Gen8BL460c G7
DL560 Gen8DL320e Gen8 v2 NEWBL460c Gen8
DL580 G7DL360 G6BL465c G7
DL585 G7DL360 G7BL465c Gen8
ML110 G7DL360e Gen8BL490c G7
ML310e Gen8DL360p Gen8BL620c G7
ML310e Gen8 v2 NEWDL380 G6BL660c Gen8
ML350 G6DL380 G7BL680c G7
Restrictions:
• Configuring iSCSI and FC HBAs is not supported. They need to be preconfigured.
• Performing a correct deployment to servers with multiple storage controllers or multiple disks
available (either multiple DAS or SAN attach) is not supported by default.
• Performing a deployment to servers with iSCSI storage is only supported on HP NC55#
controllers.
• Performing a PXE-based deployment through the HP NC540-series network adapters is not
supported.
Supported System Center products 5