HP OmniBook Plug-In Modules User’s Guide 1-1
Notice This manual and any examples contained herein are provided “as is” and are subject to change without notice. Hewlett-Packard Company makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard Co. shall not be liable for any errors or for incidental or consequential damages in connection with the furnishing, performance, or use of this manual or the examples herein.
Contents 1. Using OmniBook Plug-In Modules.......................... To install hot-swap support ............................... To replace a plug-in module............................... Using the Floppy disk drive ............................... To connect the floppy disk drive externally .................. Insert or eject a floppy disk ............................. Using the CD-ROM drive ................................. To insert or remove a CD ...............................
1 Using OmniBook Plug-In Modules 1-5
Using OmniBook Plug-In Modules The OmniBook Plug-in Modules User’s Guide describes OmniBook plug-in accessory modules and shows you how to install and use them. For complete information about operating the OmniBook, consult the OmniBook Reference Guide and the online User’s Handbook. This manual explains how to ♦ Install hot-swap support ♦ Replace a plug-in accessory module in the OmniBook. ♦ Use the floppy disk drive. ♦ Use the CD-ROM drive. ♦ Use the LS-120 drive. ♦ Use the DVD drive.
Using OmniBook Plug-In Modules 8S MRWXEPP LSX W[ET WYTTSVX To install hot-swap support The Agaté Tioman "hot-swap" software for Windows 95 and Windows 98 is loaded on the hard disk, but it is not installed. If you install this software, you can switch most modules in the plug-in bay without shutting down the computer and rebooting. (This software does not support Windows NT.) • Click Start, Programs, Agaté Tioman for HP, Setup, then follow the onscreen instructions.
Using OmniBook Plug-In Modules 8S VITPEGI E TPYK MR QSHYPI 4. Gently move the release latch back until the module pops out. 5. Grasp the underside of the module firmly, and pull out. 6. With the latch in the open position, slide the new plug-in module into the OmniBook until flush with the unit. 7. Close the module release latch.
Using OmniBook Plug-In Modules 9WMRK XLI *PSTT] HMWO HVMZI Using the Floppy disk drive You can install the floppy disk drive in the plug-in module bay or attach it externally to the parallel port. This section describes how to ♦ Connect the floppy disk drive externally. ♦ Insert or eject a floppy disk.
Using OmniBook Plug-In Modules 9WMRK XLI *PSTT] HMWO HVMZI Insert or eject a floppy disk '%98-32 (S RSX MRWIVX SV VIQSZI E JPSTT] HMWO [LMPI XLI 3QRM&SSO MW EGXMZIP] VIEHMRK SV [VMXMRK HEXE 3XLIV[MWI ]SY GSYPH PSWI HEXE SV XLI 3QRM&SSO GSYPH WXST VIWTSRHMRK 1. Hold the disk with its face up, then slide it into the floppy disk drive slot until it clicks into place. 2. To remove the floppy disk, press the eject button on the front of the drive.
Using OmniBook Plug-In Modules 9WMRK XLI '( 631 HVMZI Using the CD-ROM drive You can install the CD-ROM drive module in the plug-in module bay. This section describes how to ♦ Insert or remove a CD. ♦ Open the CD-ROM drive manually. To insert or remove a CD '%98-32 (S RSX MRWIVX SV VIQSZI E '( [LMPI XLI 3QRM&SSO MW EGXMZIP] VIEHMRK HEXE 3XLIV[MWI XLI 3QRM&SSO GSYPH WXST VIWTSRHMRK ERH ]SY GSYPH PSWI HEXE 1. Press the button on the face of the CD-ROM drive.
Using OmniBook Plug-In Modules 9WMRK XLI '( 631 HVMZI To open the CD-ROM drive manually If you lose power to the OmniBook, or if you’ve removed the CD-ROM module from the OmniBook, you can manually open the CD-ROM drive to remove a CD. • Carefully insert a straightened paper clip into the emergency eject hole, as shown below.
Using OmniBook Plug-In Modules 9WMRK XLI 07 HVMZI Using the LS-120 drive The LS-120 drive reads and writes to LS-120 disks (120 MB) and to conventional 3.5inch IBM-formatted disks (1.44 MB), which are the same size and shape. However, the LS-120 drive reads and writes to LS-120 disks significantly faster than to conventional disks. You cannot boot from an LS-120 drive. This section describes how to ♦ Insert or eject a LS-120 disk. ♦ Eject a LS-120 disk manually.
Using OmniBook Plug-In Modules 9WMRK XLI 07 HVMZI The OmniBook must be powered on for normal disk ejection from the LS-120 drive. You can manually remove an LS-120 disk from the drive when power is off. • 1-14 Carefully push a straightened paper clip into the emergency eject hole located above the eject button, as shown below.
Using OmniBook Plug-In Modules 9WMRK XLI (:( HVMZI Using the DVD drive Digital Versatile Disk (DVD) is a new standard of data storage. DVD disks deliver up to seven times the storage of CDs. DVD drives can also read standard CDs. You cannot boot from a CD or DVD in the DVD drive. This section describes how to • Insert or remove a DVD disk. • Open the DVD drive manually. • Install the MPEG-2 PC Card and DVD Player software. • Play a DVD movie.
Using OmniBook Plug-In Modules 9WMRK XLI (:( HVMZI To open the DVD drive manually If you lose power to the OmniBook, or if you’ve removed the DVD module from the OmniBook, you can manually open the DVD drive to remove a DVD disk. • Carefully insert a straightened paper clip into the emergency eject hole, as shown below. To install the MPEG-2 PC Card and DVD Player software In order to play DVD movies, you must install the MPEG-2 PC Card and DVD Player software included with your DVD module.
Using OmniBook Plug-In Modules 9WMRK XLI (:( HVMZI 5. After the driver is successfully installed, run the Setup program on the CD-ROM included with the MPEG-2 PC Card and follow the installation instructions. This installs the DVD Player software onto your hard disk. 2SXI For complete instructions on the driver and player installation process, refer to the installation instructions included with the MPEG-2 PC Card.
Using OmniBook Plug-In Modules 9WMRK XLI 7IGSRH &EXXIV] Using the Second Battery To increase the time you can work on battery power, you can install a second battery in the OmniBook’s plug-in module bay. This battery module is the same as that used in the main battery bay. This section contains instructions on the following: • To handle and store the battery safely. • To maintain and preserve the battery life.
Using OmniBook Plug-In Modules 9WMRK XLI 7IGSRH &EXXIV] To maintain and preserve battery life To preserve the life of your battery, be sure to charge the battery regularly. In cases of long-term storage, the battery must be charged at 20–50% to prevent capacity loss by self-discharge and to avoid deterioration of battery performance. • Do not leave batteries unused for long periods of time. If you have more than one, rotate them.
2 Troubleshooting 1-21
Troubleshooting If you run into problems installing your OmniBook accessories, you can use the suggestions in this chapter to correct the problems. If you have questions that this manual doesn’t answer, you can • Check the problem-solving suggestions and references listed in the troubleshooting section of this manual, the OmniBook Reference Guide, and the online User’s Handbook. • Check with your computer system administrator, if you have one.
Troubleshooting 7SPZMRK 4VSFPIQW [MXL 4PYK -R %GGIWWSVMIW Solving Problems with Plug-In Accessories If your OmniBook accessory doesn’t seem to work properly, find the symptom below that matches your situation. Try the suggestions one at a time. For information about the latest software drivers, go to the HP OmniBook website at http://www.hp.com/omnibook. This section separates problems into the following categories: ♦ Floppy disk drive problems. ♦ CD-ROM drive problems. ♦ LS-120 drive problems.
Troubleshooting 7SPZMRK 4VSFPIQW [MXL 4PYK -R %GGIWWSVMIW CD-ROM drive problems If the CD-ROM drive stops responding • Remove and reinsert the CD disk. • Restart the OmniBook. • If restarting the OmniBook does not solve the problem, remove and reinsert the CD-ROM module. If you cannot boot from a CD in the CD-ROM drive • Check that the CD is bootable. • Restart the OmniBook. • Remove and reinsert the CD-ROM module. • Run the BIOS Setup utility to make sure that the CD-ROM drive is the first boot devices.
Troubleshooting 7SPZMRK 4VSFPIQW [MXL 4PYK -R %GGIWWSVMIW DVD Drive Problems If the DVD drive stops responding ;EVRMRK • Remove and reinsert the DVD disk. • Reset the OmniBook. • Remove and reinsert the DVD module. • You cannot boot from a CD or DVD in a DVD drive.
Troubleshooting 7SPZMRK 4VSFPIQW [MXL 4PYK -R %GGIWWSVMIW • Move the OmniBook away from any nearby heat source. Unplug the ac adapter and allow the battery to cool down. An elevated battery temperature prevents charging. If the battery runs down too fast • If the operating time has gotten shorter and the battery pack is more than a year or two old, you may need a new battery. If the OmniBook turns off immediately after it turns on • Battery power is probably extremely low.
3 Specifications and Regulatory Information 1-27
Specifications and Regulatory Information Your OmniBook accessories are designed to provide trouble-free operation. The following suggestions can help you while working with your OmniBook: ♦ Observe the temperature limits and other specifications listed in the next section. ♦ If you think your OmniBook might need repair service, see the warranty and service information in the Support and Service booklet.
Specifications and Regulatory Information ,EVH[EVI 7TIGMJMGEXMSRW ERH 7EJIX] Hardware Specifications and Safety *PSTT] HMWO HVMZI Modular 3.5-inch 1.44-MB floppy disk drive with parallel cable (available separately) for internal or external use. '( 631 HVMZI Modular drive. Photo-CD and CD-plus multi-session specification compliant, multimedia PC-3 specification compliant, supports sampling and digital filter for CD audio, software and manual eject. 07 HVMZI Reads / writes LS-120 disks (120 MB).
Specifications and Regulatory Information 6IKYPEXSV] -RJSVQEXMSR Regulatory Information This section presents information that shows how the OmniBook plug-in modules comply with regulations in certain regions. Any modifications to the OmniBook or plug-in modules not expressly approved by Hewlett-Packard could void the authority to operate the OmniBook in these regions. U.S.A. The floppy disk drive generates and uses radio frequency energy and may interfere with radio and television reception.
Specifications and Regulatory Information 6IKYPEXSV] -RJSVQEXMSR Declaration of Conformity 6IWTSRWMFPI 4EVX] Hewlett-Packard Company Manager of Corporate Product Regulations 3000 Hanover Street Palo Alto, CA 94304 (415) 857-1501 declares that the product(s) 8VEHI REQI Hewlett-Packard Company 4VSHYGX REQI F1472A floppy disk drive F1465A DVD drive F1470A LS-120 F1474A CD-ROM drive Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
Specifications and Regulatory Information 6IKYPEXSV] -RJSVQEXMSR Europe Products sold in Europe by Hewlett-Packard and its authorized dealers meet the specifications listed below. Declaration of Conformity (according to ISO/IEC Guide 22 and EN 45014) 1ERYJEGXYVIV %HHVIWW 4VSHYGX REQI 3TXMSRW 7EJIX] )1' 7YTTPIQIRXEV] -RJSVQEXMSR Hewlett-Packard Company Hewlett-Packard Co. Mobile Computing Division 19310 Pruneridge Ave.
Specifications and Regulatory Information 6IKYPEXSV] -RJSVQEXMSR Declaration of Conformity (according to ISO/IEC Guide 22 and EN 45014) 1ERYJEGXYVIV %HHVIWW 4VSHYGX REQI 3TXMSRW 7EJIX] )1' 7YTTPIQIRXEV] -RJSVQEXMSR Hewlett-Packard Company Hewlett-Packard Co. Mobile Computing Division 19310 Pruneridge Ave.
Specifications and Regulatory Information 6IKYPEXSV] -RJSVQEXMSR Declaration of Conformity (according to ISO/IEC Guide 22 and EN 45014) 1ERYJEGXYVIV %HHVIWW 4VSHYGX REQI 3TXMSRW 7EJIX] )1' 7YTTPIQIRXEV] -RJSVQEXMSR Hewlett-Packard Company Hewlett-Packard Co. Mobile Computing Division 19310 Pruneridge Ave.
Specifications and Regulatory Information 6IKYPEXSV] -RJSVQEXMSR Declaration of Conformity (according to ISO/IEC Guide 22 and EN 45014) 1ERYJEGXYVIV %HHVIWW 4VSHYGX REQI 3TXMSRW 7EJIX] )1' 7YTTPIQIRXEV] -RJSVQEXMSR Hewlett-Packard Company Hewlett-Packard Co. Mobile Computing Division 19310 Pruneridge Ave.