Network Guide

● Automatic: AES or TKIP is in use.
● Not applicable: this parameter does not apply to this network type.
WEP aims to provide security by encrypting data over radio waves so that it
is protected as it is transmitted from one end point to another. This security
method is common on wireless networks.
Access Point HW
Address
The hardware address of the access point on the network to which the
HP all-in-one is connected:
● <MAC address>: the unique MAC (media access control) hardware
address of the access point.
● Not applicable: this parameter does not apply to this network type.
Miscellaneous
The following table describes the data transmission and receipt information shown on the network
configuration page.
Parameter
Description
Total Packets
transmitted
The number of packets transmitted by the HP all-in-one without error since it
has been turned on. The counter clears after the HP all-in-one is turned off.
When a message is transmitted over a packet-switching network, it is broken
up into packets. Each packet contains the destination address as well as the
data.
Total Packets
received
The number of packets received by the HP all-in-one without error since it
has been turned on. The counter clears after the HP all-in-one is turned off.
(continued)
HP all-in-one Network Guide 25