User's Manual

6. Follow the onscreen instructions to complete all the installation steps, including
the Setup Assistant.
When you have finished installing the software, your HP All-in-One is ready for
service.
7. To test your network connection, go to your computer and print a test page to
your HP All-in-One. For more information, see Print from your computer.
Connect additional computers
If your HP All-in-One is connected to one of the recommended networks you can
share your HP All-in-One with additional computers on the network. For each
additional computer, you must install the HP All-in-One software, as described in
Install the software for a network connection. During installation, the software will
discover the SSID (network name) of the existing network. Once you have set up your
HP All-in-One on the network you will not need to configure it again when you add
additional computers.
Manage your network
This section describes how to use the network tools on the HP All-in-One control
panel and the Embedded Web Server. These tools enable you to view and edit
network settings, and add advanced security to your network.
Use the HP All-in-One control panel
Print and view a network configuration page
The Network Configuration Page lists all of the important network settings such as
the IP address, link speed, DNS, and DNS-SD.
To print a network configuration page
1. Press Setup.
2. Press 8, and then press 1.
This selects the Network Setup menu and then selects Print Network Settings.
3. Press 1 or OK to confirm.
For definitions of the items on the configuration page, see Configuration page
definitions.
Restore network defaults
If necessary, you can reset the HP All-in-One network to factory defaults.
To reset to factory defaults
1. Press Setup.
2. Press 8, and then press 4.
This selects the Network Setup menu and then selects Restore Network
Defaults.
3. Press OK to confirm.
User Guide 139
Set up your network