User's Manual

Ethernet connection to a wireless network
Your access point connects a wired device to a wireless network. In this model, your
computer is configured for wireless networking using a wireless network adapter, and
transfers and receives data through the access point. Your HP All-in-One is
configured for wired networking and is connected with an Ethernet cable to the access
point. A DSL or cable modem can provide Internet access. For connection
instructions, see Connect to an Ethernet network.
Note In this configuration, we recommend that you route the Internet
connection directly through the access point using an Ethernet cable.
Connect to an Ethernet network
Use this chapter to connect your HP All-in-One to a router, switch, or access point
using an Ethernet cable.
For ideas on how to set up a wired network, see Choose a recommended Ethernet
network.
Note For definitions of terms not defined here, see the Network glossary.
To connect your HP All-in-One to your computer, first see the next section for the
things you will need. When you are finished connecting your HP All-in-One, you will
need to install the software as described in Install the software for a network connection.
User Guide 135
Set up your network