Setup Poster

2 • HP all-in-one
4
6
The control-panel overlay must be attached for the HP all-in-one to work!
5
ab
Attach the control-panel overlay (if not attached)
Load plain white paper
a Align the tabs of the control panel
overlay with the device, and then
lower.
b Press down fi rmly on all edges and
in the center of the overlay until it
snaps into place.
Connect the power cord and adapter
a Insert the bottom paper tray. b Slide the paper adjuster over. c Insert paper.
d Insert the top (output) tray. e Pull, and then fl ip the tray extender out.
Important: Do NOT connect the USB
cable until Step 16 or software may not
install properly.