Setup Poster

hp officejet 5500 series all-in-one
1
3 4
6
2
87
9
10
5
11
12
www.hp.com/support
Copyright Hewlett-Packard Company 2003
a
b
c
Macintosh OS 9, OS X
a
b
c
hp_all-in-one_installer
a
b
c
Macintosh
a
b
d
c
e
2
1
a
c
b
Remove the bright pink
tape from the print
cartridges. Do not touch the
gold-colored contacts or
retape the cartridges.
Lift the print-carriage
access door. The print
carriage slides to the
middle.
Hold the black print cartridge with the large
HP label and the raised markings on top.
Slide the cartridge at a slight angle into the
right side of the print carriage.
Press firmly until the print cartridge snaps
into place.
Close the print-carriage access door and
press the OK button. Within a few minutes, a
print cartridge alignment page prints.
Place the alignment page face down in the
left front corner of the glass. Close the lid.
This side of the poster
is for Macintosh users
only.
Follow the steps on
this poster in order.
Hold the tri-color print cartridge with the large HP
label and the raised markings on top. Slide the
cartridge at a slight angle into the left side of the print
carriage.
Press firmly until the print cartridge snaps into place.
Make sure that both print cartridges are secure.
Press the OK button.
When "Alignment is
complete" appears on the
display, alignment is
complete. Discard or recycle
the alignment page.
Macintosh setup poster
Printed in Singapore/Malaysia
Macintosh users START HERE
Attach the front panel covers
Load plain white paper
Connect the power cords
Unpack the device
Connect the supplied phone cord
Turn on the device and set the
language and country/region
Connect the USB cable
Open the print-carriage access door
Insert and align the print cartridges
Align the larger cover over the buttons
on the top of the HP Officejet and snap
into place.
Align the smaller cover over the buttons
on the front of the HP Officejet and
snap into place. Make sure all the
buttons can move freely.
Try the HP Officejet
Congratulations! You are now ready
to use the HP Officejet. Select the HP
Director icon in the dock to get
started.
If you encounter problems during
setup, see the Reference Guide.
Install the software
Turn on your Macintosh
and wait for it to finish
starting up.
Insert the Macintosh
HP Officejet CD.
Double-click the
HP All-In-One Installer
icon on the desktop.
Follow the onscreen
instructions. You may
have to restart your
Macintosh during setup.
Be sure to complete the
setup assistant.
Press the On button to turn on the
device. Wait for the display prompt.
Select your language, then press the OK
button.
Select your country/region, then press
the OK button.
If you have an iMac, the
USB port is on the side.
Do not connect the HP
Officejet to a USB port
on a keyboard or a non-
powered USB hub.
a
b
Tri-color Black
Door
Connect the supplied phone cord to
the open 1-LINE jack on the left.
To connect other equipment such as
an answering machine, or to use a
different cord, see the Fax Setup
chapter in the Reference Guide.
*Q3434-90196* *Q3434-90196*
Q3434-90196