User's Manual

The telephone line is silent while the fax is transmitting. At this point, you can

hang up the telephone. If you want to continue speaking with the recipient,

remain on the line until the fax transmission is complete.

To send a fax manually from a phone using the attached handset (handset

model only)

1. Load your originals print side down and top first in the center of the document

feeder tray.

2. Pick up the handset that is attached to the HP All-in-One and dial the number by

using the keypad on the control panel.

3. If the recipient answers the telephone, you can engage in a conversation before

sending your fax.

Note If a fax machine answers the call, you will hear fax tones from the

receiving fax machine. Proceed to the next step to transmit the fax.

4. Once you are ready to send the fax, press Start Black or Start Color.

Note If prompted, press 1 to select Send Fax, and then press Start

Black or Start Color again.

If you were speaking with the recipient before sending the fax, inform the

recipient that they should press Start on their fax machine after they hear fax

tones.

The telephone line is silent while the fax is transmitting. At this point, you can

hang up the telephone. If you want to continue speaking with the recipient,

remain on the line until the fax transmission is complete.

Send a fax using monitor dialing

Monitor dialing allows you to dial a number from the control panel as you would dial a

regular telephone. When you send a fax using monitor dialing, you can hear the dial

tones, telephone prompts, or other sounds through the speakers on the HP All-in-

One. This enables you to respond to prompts while dialing, as well as control the pace

of your dialing.

Tip If you do not enter your calling card PIN fast enough, the HP All-in-One

might start sending fax tones too soon and cause your PIN not to be

recognized by the calling card service. If this is the case, you can create a

speed dial entry to store the PIN for your calling card.

Note Make sure the volume is turned on, or you will not hear a dial tone.

To send a fax using monitor dialing from the control panel

1. Load your originals print side down and top first in the center of the document

feeder tray.

2. Press Start Black or Start Color.

User Guide

Fax