User's Manual

b. In the Internet & Network area, click Sharing.

c. From the Services tab, click Printer Sharing.

2. On the host computer, do the following:

a. Click System Preferences in the Dock, or, from the Apple menu, choose

System Preferences.

The System Preferences dialog appears.

b. In the Hardware area, click Print & Fax.

c. Do one of the following, depending on your OS:

• (OS 10.2.8 or 10.3.x) From the Printing tab, click the check box to

Share my printers with other computers.

• (OS 10.4.x) Click Sharing, click the check box to Share this printer

with other computers, and then select the printer to share.

Fax setup

After completing all the steps in the Setup Guide, use the instructions in this section to

complete your fax setup. Please keep your Setup Guide for later use.

In this section, you will learn how to set up the HP All-in-One so that faxing works

successfully with equipment and services you might already have on the same phone

line as the HP All-in-One.

● Set up the HP All-in-One for faxing

● Change settings on the HP All-in-One to receive faxes

● Test your fax setup

● Set the fax header

Set up the HP All-in-One for faxing

Before you begin setting up the HP All-in-One for faxing, determine which kind of

phone system your country/region uses. The instructions for setting up the HP All-in-

One for faxing differ depending on whether you have a serial- or parallel-type phone

system.

● If you do not see your country/region listed in the table below, you probably have

a serial-type phone system. In a serial-type phone system, the connector type on

your shared telephone equipment (modems, phones, and answering machines)

does not allow a physical connection to the "2-EXT" port on the HP All-in-One.

Instead, all equipment must be connected at the telephone wall jack.

Note In some countries/regions that use serial-type phone systems, the

phone cord that came with the HP All-in-One might have an additional wall

plug attached to it. This enables you to connect other telecom devices to

the wall jack where you plug in the HP All-in-One.

● If your country/region is listed in the table below, you probably have a parallel-

type telephone system. In a parallel-type phone system, you are able to connect

shared telephone equipment to the phone line by using the "2-EXT" port on the

back of the HP All-in-One.

Chapter 3

HP Officejet 4300 All-in-One series

Finish setup