User's Manual

Table 11 Indications for the iLO 3 TUI LEDs (continued)
NOTE: If the SYSTEM LED lights red,
this counts as a FRU failure for the
HEALTH LED.
Health of the partition is FATAL and the
health of one or more blades within the
partition are FATAL, meaning that:
• A FRU has failed and A fatal event has
been logged (Level seven events cause
this indication if there are FRU failures
on one of the blades in the partition.)
A reset will clear this LED of a fatal event,
but not a FRU failure. A power cycle will
clear both.
Flashing
red
All internal FRUs in the partition are
healthy, there are no fatal events, and the
system power is on.
Steady
green
Power to the system/partition is off and
there were no AMBER or RED HEALTH
indications on the last boot.
Off
There has been a FATAL event since the
last power on or system reset.
A reset or power on will clear this LED.
Flashing
red
• System Event Log
Health as displayed
on the System Health
page in the iLO 3
GUI
• There is no physical
LED on the blade's
front panel that
represents this state.
There is only one
SYSTEM LED per
partition. The state will
be the same for every
blade in the partition.
SYSTEM
System is beginning to boot the OSSteady
green
OS is not booting and there are no fatal
events.
Off
The system/partition is identified.OnIdentifies the
system/partition and will
LOCATOR
UID LED on the front
panel of the
individual blade
•
System/partition is not identified and no
firmware update is actively writing to any
of the system ROMs
Off
blink while a firmware
update is in progress.
NOTE: All blades in a
partition show the same
LOCATOR status at all
times.
NOTE: You can toggle
the UID in software from
either the iLO 3 TUI or
web GUI. There is no
UID hardware button on
the server blade itself to
turn it on or off.
• Locator UID in iLO 3
• Virtual Indicator in
the Onboard
Administrator’s
interface
Power should not be interrupted; firmware
is actively burning a ROM.
NOTE: On ProLiant servers this LED
blinks to indicate remote management;
however this is not currently a supported
indication on Integrity servers.
Flashing
Toggles the current LED state to indicate
transitional mode states activated by a
push and hold of the Physical Presence
button.
If the Locator is off it will toggle on and
then off, but if the Locator is on, it will
ON/OFF
toggle
toggle off and then on. If the Locator is
flashing, no action will be taken.
System/partition is fully powered on.Steady
green
Identifies the
system/partition power
state.
POWER
Monarch Power
button LED on the
front panel of the
Monarch blade
•
System/partition is in standby.Steady
amber
• System Power LED in
the iLO 3 GUI
The system/partition is powered off.Off
90 Troubleshooting