User's Manual

StatusDescriptionItem
Amber = Blade is acting as Monarch
and is in standby
Off = Blade is not Monarch
N/ASUV connector6
N/APhysical Presence Button7
Green = Blade is in a partitionPartition Identifier8
Off = Blade is not in a partition
Green = Server blade is powered onBlade power LED9
Amber = standby (auxiliary power
available)
1
Off = Off
Green flashing = iLO 3 Active
Amber flashing = iLO 3 failure
iLO 3 Heartbeat (behind grill)10
Off = no standby voltage
1
If the Onboard Administrator denies power to the server blade, the server blade returns to Standby mode.
SAS disk drive LEDs
The BL860c i4 Sever Blade may have up to 2 hard disk drives installed. Each drive has two LEDs
which display the drive status.
DescriptionItem
Fault/UID LED (amber/blue)1
Online LED (green)2
SAS hard drive LED combinations
NOTE: Predictive failure alerts only occur when the hard drive is connected to a Smart Array
controller.
InterpretationFault/UID LED (amber/blue)Online/activity LED (green)
The drive has failed, or a predictive
failure alert has been received for this
Alternating amber and blueOn, off, or flashing
drive; it also has been selected by a
management application.
The drive is operating normally, and it
has been selected by a management
application.
Steadily blueOn, off, or flashing
A predictive failure alert has been
received for this drive. Replace the drive
as soon as possible.
Amber, flashing regularly (1 Hz)On
Troubleshooting tools 87