User's Manual

-> Command successful.
d. After the iLO 3 MP reset (less than one minute), log back into the iLO 3 MP, go to the
Command Menu, and enter sysset again to verify that the system information parameters
have been set for correctly for both Primary and Secondary. The values between Primary
and Secondary should now match.
[ilo002264fee1be] CM:hpiLO-> sysset
SYSSET
Current System Information Parameters:
Manufacturer : HP
Product Name (prodname) : Integrity BL860c i4
Secondary Product Name : Integrity BL860c i4
Product Number (prodnum) : AM377A
Secondary Product Number : AM377A
Serial number (serial) : SGH2101LRY
Secondary serial number : SGH2101LRY
UUID (uuid) : 59F30FC7-8A4A-11E1-AF3F-DC6163A31240
Secondary UUID : 59F30FC7-8A4A-11E1-AF3F-DC6163A31240
Product ID : 0x711
13. Remove the Field Upgrade Only sticker from the bezel of the Upgrade Blade Link. This is no
longer a Field Upgrade Blade Link because the Serial Number and UUID have now been
programmed on the Blade Link.
14. As mentioned earlier, the nPartition configuration of the upgraded server defaults to a single
partition. An example of what might be seen entering the npar command from the iLO 3 MP
Command Menu is shown below for an upgrade to a BL890c i4.
[ilo80c16e9877f4] CM:hpiLO-> npar
NPAR
Current nPartition Configuration:
Bay 1 2 3 4
---------------------------------------------------------------------
nPartition : A A A A
Domain MP : yes - - -
Power Off : yes - - -
nPartition Unlocked : - - - -
nPartition Menu:
Current -> AAAA - One 4-Blade System (default)
AACC - Two 2-Blade nPartitions
AACD - One 2-Blade nPartition, and Two 1-Blade nPartitions
ABCC - Two 1-Blade nPartitions, and One 2-Blade nPartition
ABCD - Four 1-Blade nPartitions
Enter new value, or [Q] to Quit:
When a blade is changed from one nPartition to another, the system variable and configuration
information is cleared. This provides a convenient method for ensuring that all Auxiliary blades
in the upgraded server are cleared of stale or inconsistent information. Set the nPartition
configuration to the highest number of partitions possible for the upgraded server. For a
BL870c i4 that will be two (AB) while for a BL890c i4 that will be four (ABCD). The iLO 3 MP
will automatically reset for the change to take effect. An example output is shown below for
a BL890c i4. Note that since the Monarch blade never changes partitions (it always remains
in the 'A' partition), that blade will not have its system environment variables cleared.
[ilo80c16e9877f4] CM:hpiLO-> npar -config abcd -nc
NPAR -config abcd -nc
New nPartition Configuration (* marks modified systems):
Bay 1 2 3 4
---------------------------------------------------------------------
66 Optional components