User's Manual

Examples 803
configure a device with an IP address, refer to the user documentation
that is supplied with your device.
2 Configure one of the devices with the desired port security and VLAN
settings. This will be referred to as the source device.
By giving the source device an easily identifiable system name at this
stage, you will be able to find the source device more easily when using
the Device Setup Wizard.
3 Connect the management station to all of the new switches using an
Ethernet connection through a hub or switch.
4 Using the Add Device option or by importing the IP addresses from a CSV
file, create a new map and add the new switches to the map.
5 Launch the Device Setup Wizard using the toolbar button on the main
screen. Select Next at the Introduction step to display the Configuration
Source Type step and select the Live Device radio button.
6 Select Next to display the Specify Source Device step and locate the
source device in the table as shown in Figure 441
:
Figure 441 Specify Source Device Example
7 Select Next to display the Specify Devices to Setup step and select all of
the devices listed so that the configuration of the source device is applied
to all the remaining new switches.