User's Manual

Restore Components 791
Figure 432 Specify Telnet Login Information Step
If this step is displayed, you will need to provide the Telnet username and
password for the device you have selected to restore.
■ Username — specifies the username used to log in to the selected
devices, via Telnet. This can be a maximum of 32 characters.
■ Password — specifies the password used to log in to the selected
devices, via Telnet. This can be a maximum of 24 characters.
The username and password may be left blank.
Summary Step and Progress
Once you select Finish on the Summary step the Device Restore operation
is ready to begin.
Before any configuration takes place, the Device Restore operation
displays a warning dialog box. The dialog box advises you to ensure that
the target device is isolated from your network before proceeding. You
must acknowledge this warning before continuing. See “
Key
Considerations” on page 808 for further information.
During the Device Restore operation, the Device Restore Progress dialog
box is shown to indicate the progress of the operation.
The Device Restore Progress dialog box can be minimized to the status
bar of the application by clicking Minimize in the bottom left hand corner
of the Progress dialog box.