User's Manual

616 CHAPTER 14: BULK CONFIGURATION

Figure 340 Configuration Template Editor – Radius Servers

4 Enter the IP address, port and shared secret for the primary and backup

RADIUS authentication and accounting servers. Choose the appropriate

action for accounting failures.

5 Click the Edit Selection button in the Configuration Editor dialog box to

launch the Selection Editor dialog box, and click the Add Device button in

the Selection Editor dialog box to launch the Find Device dialog box.

Choose the Find by type option, select the Switch 4400 device type from

the drop down list, and click Find. Highlight the Switch 4400 devices that

provide the network connections for the new hot-desking area. Click OK

to add the devices to the selection of devices to be configured.

It is possible to save the selection of devices, to allow the application of

another configuration to the same devices at a later date.

6 Click OK in the Selection Editor dialog box, and then click OK in the

Configuration Editor dialog box to run the bulk configuration of the

selected devices.

7 In the Schedule Configuration dialog box, select the Now radio button to

start the bulk configuration operation immediately.

Once the bulk configuration operation has successfully setup the RADIUS

Server details on all of the selected switches 3Com Network Director will

be ready to configure the appropriate switch ports to use the network