User's Manual

604 CHAPTER 14: BULK CONFIGURATION
Figure 329 Spanning Tree Panel
The Spanning Tree mode setting will only be applied as part of the
configuration template if the associated checkbox is checked. The
remaining parameters for this feature will only be applied as part of the
configuration template if both the associated checkbox and the Spanning
Tree mode check box are checked and the Spanning Tree mode is not set
to Disabled.
The Spanning Tree feature places restrictions on the values that can be set
for the following parameters:
Table 94 Spanning Tree Parameter Restrictions
Parameter Restriction
Spanning Tree
Mode
The Spanning Tree mode can be one of: Rapid Spanning
Tree, Spanning Tree or Disabled.
Bridge Priority The Bridge Priority must be in the range 0-61440 (in steps
of 4096) if the Spanning Tree mode is set to Rapid
Spanning Tree or 0-65535 if the Spanning Tree mode is set
to Spanning Tree.
Hello Time The Hello Time value must be in the range 1-9.
Max Age The Max Age value must be in the range 6-28. See note
below.
Forward Delay The Forward Delay Time value must be in the range11-30.
Default Path Cost
Algorithm
The default path cost algorithm must be one of: 802.1D or
802.1t