User's Manual

602 CHAPTER 14: BULK CONFIGURATION
Figure 327 Trap Destinations Panel
The trap destination table will only be applied as part of the configuration
template if the associated checkbox is checked. The table defines the
addresses to which the device will send SNMP traps, each entry has the
following parameters:
Table 93 Trap Destination Table Entries
In a new configuration template the table will be empty. New trap
destination entries can be added to the list, one at a time, by clicking the
Add button.
A maximum of eight entries can be added to the table. The IP address,
community string and owner string for any of the entries in the list can be
modified, by selecting the desired entry in the list and clicking the Edit
button.
Parameter Description
IP Address The IP address of the device to which SNMP traps should
be sent.
Community String The community string has a maximum length of 30
characters.
Owner A description of the owner of this trap destination entry.
Maximum length 128 characters.