User's Manual

Components 591
Status information for each device is shown in the table below the
progress bars. The information shown depends on the stage of the
configuration operation for each device, as summarized in the following
table:
Table 90 Device Status Information
The Configuration Progress dialog box can be minimized into the status
bar of the application. Note that if the configuration operation was
scheduled to start at a later date or time, then it will appear in this
minimized state initially, by default.
The configuration operation can be cancelled at any time. If cancel is
chosen the configuration process for the current device will cease
immediately. However, any configuration changes that have already been
made to any device will not be reversed.
Configuration
Summary Report
When the configuration operation completes, the Configuration
Summary report is automatically generated. The report can be viewed
from the Configuration Summary dialog box that is shown at the end of
the operation.
It is strongly recommended that the summary report for a configuration
operation is always reviewed as the report may contain important
information about the changes that were made.
Device Status Configuration Stage
Pending The configuration operation has not yet been started on
this device.
Verifying device
properties
Displayed at the beginning of the configuration process for
a device, while the application checks that the device on
the network has not been changed since it was selected.
Configuring device Displayed while the configuration template is being applied
to the device.
Success Displayed when the configuration process for the device
has completed successfully
Failed Displayed when the configuration process for the device
has failed due to one or more errors. Note that the reason
for the failure will be detailed in the summary report for
the operation.