User's Manual

586 CHAPTER 14: BULK CONFIGURATION
Devices will be shown in the tree, using the label that is currently being
used on the map. The devices shown can be expanded to show the
individual units that they contain.
Devices can be removed from the selection by highlighting the desired
devices in the tree and then clicking the Remove Device button.
Whenever this is done the tree will be updated to remove the chosen
devices indicating that they are no longer selected.
If a device is added to the selection that is not supported by the bulk
configuration operation, the device appears in the selection editor with a
brief note next to the device name indicating the reason that the device is
not supported. Unsupported devices cannot be expanded, to view the
individual units that they contain, using the Selection Editor dialog box.
The bulk configuration operation will not attempt to configure any
unsupported devices that are present in the selection.
While editing a port selection it is also possible to expand the individual
units in the selection contents tree to show the ports available on each
unit. Note that all ports available on the units will be shown in the tree,
regardless of whether they are selected or not. However, to differentiate
between them selected ports will be shown in black with a green tick
next to them, and unselected ports will be shown in grey with no tick.
Ports may be added to the selection by highlighting the desired ports in
the tree and then clicking the Add Port button. Whenever this is done the
tree will be updated to show a green tick next to each port that was
highlighted, indicating that it is now selected.
Ports can be removed from the selection by highlighting the desired ports
in the tree and then clicking the Remove Port button. Whenever this is
done the tree will be updated to remove the green tick next to each port
that was highlighted, and grey the port entry, indicating that it is no
longer selected.
To add ports belonging to a device that is not currently shown in the
selection the device must first be added, using the Add Device button.
Individual ports can then be selected on this device as explained above.
All ports belonging to a particular device can be quickly added or
removed from the selection, by selecting the device, and then clicking the
Add Port button or Removed Port button respectively.