User's Manual

540 CHAPTER 13: VLAN MANAGEMENT
these end-stations and list this in the Edit ports wizard stage, namely the
port on the Switch 1100 connected to the hub.
Figure 288 The Nearest Switch Port to the Non-Switch
The Tagged table column in this wizard stage indicates whether a switch
port is to be a tagged or an untagged member of the new VLAN. See
“
Tagged and untagged VLAN membership” on page 503.
By default, 3Com Network Director assumes that:
■ inter-switch ports will be tagged
■ ports connected to non-switches will be untagged.
So, in the example above 3Com Network Director would assume that the
port on the Switch 1100 connected to the Hub should be untagged.
To modify the switches and switch ports listed in this wizard stage, click
the Change Selection button to launch the Selection Editor dialog box.