User's Manual

470 CHAPTER 11: CREATING REPORTS
5 Click Next and enter Agents on units as the report name and provide a
description.
6 Click Next.
7 After reviewing the details on the Summary step, click Finish.
8 Click OK in the Custom Report Types dialog box to confirm the custom
report type addition.
9 Select Agents on units in the list of report types and click Generate
Report.
The report will enable you to see at a glance which stacks have more than
one unit and what the unit agent versions are, allowing you to locate
units that require agent version changes.
Key Considerations The following section provides some useful advice when using the
Reports feature in 3Com Network Director.
Report Information
Out-of-Date
The information that appears in Reports is based on information held in
the current map file. If changes have occurred since the last discovery
operation, the report will contain out-of-date information. The one
exception to this is the Prioritization Configuration report, which uses
SNMP queries on your network devices to generate this report.
Disk Usage Generated reports are not aged or deleted automatically in any way.
Therefore, over a period of time, the number of reports stored on disk will
build up. One generated report will take up approximately 4KB to 5KB,
depending on the number of devices reported on. You can delete
generated reports from the History tab of the Reports dialog box.
If you have more than 500 generated reports stored, 3Com Network
Director will display a warning when you launch the Reports dialog box.
This is purely for information and will not affect the operation of 3Com
Network Director in any way.