Service manual

Chapter 4 Diagnostics
31
Table 4-2. POST Error Codes
Code Description Problem/Solution
0000 System Board error POST has detected a failure limited to the system board internal
functions.
To verify this error:
1. Reboot the Netserver.
Skipping this error message and continuing may result in
unstable behavior, or a system hang during the boot process.
2. If this error continues, the system board may need to be
replaced. Contact your service representative to replace your
Netserver.
0010 BIOS problem The PC configuration has been lost, cleared, corrupted, or has not
been initialized. When the HP Netserver remains unplugged for a
long period of time, the battery will discharge and not provide
enough current to keep the CMOS memory powered.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery as described later in this
chapter.
3. Run the Setup Utility to re-configure your Netserver.
0011 Battery problem The Netserver BIOS is not responding due to a possible battery
discharge. If the HP Netserver was unplugged for a long period of
time, the battery will discharge and not provide enough current to
keep the system date and time current.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery.
3. Set time and date using the Setup Utility and in your
operating system, if necessary.
0012 BIOS initialization
problem
The HP Netserver configuration has been cleared or has not been
initialized.
Run the Setup Utility to re-configure your Netserver.
0020 ISA initialization
problem
(This does not apply
to LP 2000r)
The ROM on the accessory board is bad or the board has a conflict
with a system board reserved resource (address, DMA, or IRQ).
To correct this:
1. Change the resources used by the ISA accessory boards.
2. Try to disable <free> resources used by system board
devices.
3. If the problem persists, the accessory board may be
defective. Contact the accessory board vendor.