Installation guide

Chapter 1 Introduction
5
Tools You Need
The following materials are also required to install this upgrade:
•
Anti-static Service Kit (3M part number 8501/8502/8505 or equivalent)
containing a wrist strap, anti-static mat, and cable. Use this kit to prevent
damage to the system from static electricity.
•
T15 Torx
®
driver
•
T25 Torx driver (required for systems mounted in HP racks)
• HP NetServer Navigator CD-ROM (used for RAID configuration)
Documents You May Need
Refer to the following documents supplied with your HP NetServer:
• HP NetServer LH 3000/3000r Installation Guide
• HP NetServer LH 6000/6000r Installation Guide
• Integrated HP NetRAID Controller Configuration Guide
The HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide
is supplied with accessory Ultra2 SCSI hot-swap hard disk drives and trays.
The HP NetServer Duplex Board Installation Guide is supplied with the kit used
to install a duplex board.
For an HP NetServer installed in a Compaq rack, refer to the Installation Guide
for Compaq
®
4000/7000 Racks for your HP NetServer.
The HP NetServer Online Documentation CD-ROM contains all of the documents
listed above.