Installation guide

Chapter 1 Introduction
2
Chapter 2 of this guide tells how to install the second hot-swap mass storage cage
and its SCSI cable in the configuration shown in Figure 1-2.
I/O Baseboard
SE Connector
SCSI A Connector
SCSI B Connector
SCSI Cable for
Secondary Hot-Swap
Mass Storage Cage
Secondary Hot-Swap
Mass Storage Cage
(Left Drive Bay in
Pedestal Orientation)
Primary Hot-Swap
Mass Storage Cage
(Right Drive Bay in
Pedestal Orientation)
Channel B
(Secondary)
Channel A
(Primary)
Non-Hot-Swap
SCSI Devices
Figure 1-2. Cabling the Secondary Hot-Swap Mass Storage Cage
Chapter 3 tells how to configure the hot-swap disk drives.
Appendix A contains warranty and support information.
Appendix B contains regulatory information.